Read about ‘Microchip: AN – Application Note for Brushless DC Motor Control Using PIC18FXX31 MCUs’ on elementcom. Microchip. leader in motor control, Microchip is continuously designing new motor .. AN Brushless DC Motor Control Using PIC18FXX31 MCU’s. AN Sensorless. AN Brushless DC Motor Control Using PIC18FXX31 MCUs. Author: Padmaraja Yedamale Microchip Technology Inc. HARDWARE A PICDEMâ„¢ MC demo.

Author: Tojazilkree Kazicage
Country: Myanmar
Language: English (Spanish)
Genre: Finance
Published (Last): 13 April 2010
Pages: 62
PDF File Size: 18.27 Mb
ePub File Size: 1.13 Mb
ISBN: 481-7-26622-960-7
Downloads: 89180
Price: Free* [*Free Regsitration Required]
Uploader: Fetaur

Motorboard Controller Source Code (Open Source)

If low power is detected the red LED will blink, and power will be shut off completely. Navigation menu Personal tools Create account Log in.

The speed is controlled linearly, and no attempt is made to maintain a given speed for a given throttle position. Views Read View source View history. Privacy policy About Motorboards Am899 Mobile view. The controller monitors the speed of one of the motors the one with a optical wheel “chopper” attached to an elongated motor shaft.


This prevents power from being applied to the motors until they are at least rotating at 3mph. The current code cannot be read because the “Code Protect” bit has been set, but it is possible to erase the chip and program it with new code.

Motorboard Controller Source Code (Open Source) – Motorboards

The Roth motorboards “maximum” speed of 18mph translates to optical pulses per second. Retrieved from ” http: Then the operator pushes to go. If the speed of this motor is less than 3mph, no power will be provided to the motors.

One turn of the wheel is at best inches This page was last modified on 23 Marchat This saves significant amounts of battery power and prevents the motorboard from starting accidentally. When the battery is almost dead, the red light will blink and the buzzer on the motor contoller PCB will beep on and off 1 second on, 4 seconds off until the battery reaches the low power shut off.


The motorboard will am899 function and there will be no indication as to the cause of failure. When the battery gets critically low, the RED light will illuminate. When you turn the motorboard ON, the green light goes on then off, then the yellow light goes on then off then the red light goes on then off and then the green light goes on solid.

Because there is no indication that the motor is moving less than 3mph, if micfochip optical wheel fails for any reason the motorboard will assume that 3mph has not yet been reached. The motor makes approximately Actually it operates at Hz measured.

Since there are eight optical slots on the chopper per turn, this means optical pulses per turn of the wheel. The motorboard has an automatic low power shut off.